Synthetic underlayment
Underlayment rows are lapped from the eaves up before any shingle goes down.
Shingle Roofing
Shingle Roof Installation Hillside, NJ
A roofer in Hillside can install a new shingle roof from the deck up: drip edge, ice and water shield, underlayment, starter strip, shingles, flashing and ridge vent, with nailing and flashing done to the shingle instructions. Call (908) 562-6893 to reach a local roofer.
A shingle roof works as a system, not as a single product. The layers under the shingles include drip edge, ice and water shield, underlayment and starter strip, each with its own job. Flashing at every wall, chimney, valley and pipe, plus intake and exhaust ventilation, finishes the system.
Shingle choice sets the look, the wind rating and the life of the roof. 3-tab shingles are thin and uniform, and architectural shingles are thicker laminated shingles with a textured, shadowed look and higher wind ratings. Where hail is a concern, Class 4 impact-resistant shingles are worth a look, and your insurer can tell you whether they change anything on your policy.
Shingles are made for sloped roofs. The usual minimum for shingles is a 2 in 12 pitch, with a double layer of underlayment on slopes up to 4 in 12. A low porch or shed dormer may need a membrane section joined carefully to the shingles.
If the problem goes deeper than it first looked, a Hillside roofer may also recommend shingle roof replacement or roof installation.
Need shingle roof installation in Hillside? Call (908) 562-6893 and describe the problem to a roofer who works in Hillside.
Call nowThe process
Building a shingle roof layer by layer
Each layer goes on in a set order so water always runs over, never under.
Check the sheathing
On a reroof or new build, the deck is inspected and fixed first, since shingles follow every dip beneath them. Shingles laid on a bad deck show every flaw.
Drip edge at the eaves
Metal drip edge is fastened at the eaves, and a self-adhering ice barrier covers the eaves and valleys where water and ice collect. That membrane seals around nails where ice backs water up.
Lay the underlayment
Synthetic underlayment or felt is rolled out in overlapping rows from the bottom up, then drip edge goes on along the rakes over it. Most roofers now use synthetic, which resists tearing and lies flatter than felt.
Start at the eaves
Starter shingles go on first at the eaves and rakes, putting a sealant line under the edge where wind lifts first. That is where wind damage usually begins on a poorly built roof.
Install the field
Each course is nailed in the nailing zone, never high or overdriven, and step flashing goes in piece by piece at every sidewall. Counter flashing laps over the step flashing at chimneys and walls.
Cap the roof
Exhaust at the ridge is matched to intake at the soffits so air moves through the attic. Too little intake makes a ridge vent pull air the wrong way.
What is included
What a new shingle roof includes
Eave membrane
An ice barrier lines the eaves, valleys and other leak-prone spots to seal around nails if water backs up.
Starter strip
The edges get drip edge and starter shingles which keeps wind from peeling up the first course.
Shingle selection
3-tab, architectural or impact-resistant shingles are matched to the house and to the weather the roof will face.
Ridge ventilation
New flashing and balanced ventilation finish the system which is where most leaks would otherwise start.
Related service
Architectural Shingle Installation Hillside, NJ
Architectural shingle installation follows the same order as any shingle roof, but the shingle has its own rules. Each nail has to pass through both layers in the marked nailing zone, which is narrower than on a 3-tab shingle. Matching hip and ridge cap shingles and a compatible starter keep the look and wind rating consistent.
In Hillside, NJ, architectural shingles are the common choice for both new homes and reroofs. They resist wind, add depth to the roofline and outlast flat shingles. A sample board viewed outside, next to the siding, is the best way to choose a color.
Related service
Asphalt Shingle Roof Installation Hillside, NJ
An asphalt shingle roof installation is the most common way to roof a house, and the details decide how well it performs. Problems on new roofs usually trace to high nails, skipped starter or reused flashing. Ask the roofer to explain the nailing pattern, the underlayment and how walls and valleys will be flashed.
A new asphalt roof in Hillside is usually installed in one to three days once the deck is ready. Cold weather slows the factory sealant, so shingles laid in winter may need hand sealing. Rain delays are normal because the deck has to stay dry.
Local help
Shingle Roof Installation Near Me
New shingle roofs in Hillside go on everything from new houses and additions to reroofs of older homes. From Hillside out to neighboring towns such as Union, Elizabeth, Roselle Park and Vauxhall, houses built decades ago tend to need ventilation and flashing upgrades when they get a new shingle roof, and a shingle chosen for local wind and hail makes sense anywhere storms roll through. Looking for a shingle roofer near me? Ask about the full system, from drip edge to ridge.
Need shingle roof installation around Hillside? Call (908) 562-6893 for a Hillside roofer who serves the towns around it too.
How the weather here affects roofs around Hillside
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Hillside is busiest after a hard winter and before the next one.
Why call
Why fix it now
Smaller repairs
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers who know Hillside
Local roofers see the same roofs and storm damage across Hillside and nearby towns.
Know what happens next
Ask the roofer about the cause, the options and the estimate before work starts.
Common questions about shingle roof installation
What is the best season for a shingle roof installation?
Mild, dry weather is the easiest time to install shingles. Winter installs are possible, but the shingles need gentle handling and the sealant may not bond until warmer days. Rain and snow are the real limits, since a wet deck should never be covered.
What is the minimum pitch for asphalt shingles?
The usual minimum for shingles is a pitch of 2 in 12. Roofs that are low but still within range get added underlayment protection. Porches and additions below that line need a low slope material.
Why does nail placement matter on a shingle roof?
Nail count and placement decide how well shingles stay on in wind. Four nails per shingle is common, with six where the shingle instructions or local code call for high-wind nailing. Nails set too high miss the course below, and overdriven nails cut the mat, which is how shingles blow off a new roof.
What kind of underlayment should go under shingles?
Under the shingles sit drip edge, a self-adhering ice barrier in the leak-prone areas, a full layer of underlayment and starter shingles. Synthetic underlayment has largely replaced felt because it is lighter, stronger and less likely to wrinkle or tear. The shingle instructions and local code set the minimum.
Which is better, 3-tab or architectural shingles?
The difference is construction: one flat layer for 3-tab, two laminated layers for architectural. For most homes architectural shingles are the better value over the life of the roof. A roofer can help weigh the two for your house.
More questions? Call (908) 562-6893
Often needed together
Shingle Roof Replacement
Full shingle roof replacement, from tear-off and deck repair to new shingles and flashing, so the new roof starts on a sound, dry deck.
Learn moreRoof Installation
Putting on a new roof the way the material maker intends, whether it is asphalt shingles, metal or another material.
Learn moreRoof Ventilation
Balancing attic intake and exhaust with soffit vents, ridge vents and attic fans, without mixing vent types that work against each other.
Learn moreGutter Installation
Gutter installation that carries roof water away from the siding, fascia and foundation, from K-style aluminum to half-round and copper.
Learn more
Looking for something else?
See all roofing servicesGet shingle roof installation help in Hillside
Call (908) 562-6893 for a local roofer in Hillside and nearby towns.