New underlayment
Modern underlayment replaces the worn original to protect the house for decades.
Tile Roofing
Tile Roof Replacement Hillside, NJ
A roofer in Hillside can replace a worn tile roof by removing the tile, repairing the deck, installing new underlayment and flashing, then relaying the sound tile or putting on new tile. Call (908) 562-6893 to reach a local roofer for tile roof replacement.
A tile roof rarely needs replacing because of the tile alone. Clay tile often lasts long enough to be relaid over new underlayment more than once. If the tile is cracking, eroding or impossible to match, the replacement uses new tile.
Both kinds of replacement follow one sequence. The tile comes off and is sorted, the old underlayment and battens are stripped, soft decking is replaced, and new underlayment, battens and flashing go down before tile is laid back on. A building permit is usually required, and the inspector may check the underlayment before tile goes back on.
No tile removal is perfectly clean. Even with careful handling, a share of old tile cracks during removal, so the roofer plans for matching replacement tile from salvage stock or new production. It is worth asking how breakage is handled and how new tile will be blended in.
If the problem goes deeper than it first looked, a Hillside roofer may also recommend tile roof installation or tile roof repair.
Need tile roof replacement in Hillside? Call (908) 562-6893 to reach a nearby roofing contractor.
Call nowThe process
What happens during a tile roof replacement
The goal is a new roof under tile that lasts as long as the tile on top.
Decide on the tile
A close look at the tile, the underlayment and the decking decides whether the tile goes back on or new tile is ordered. A roof with large sags should be checked from below before anyone walks on it.
Take off the tile
Tiles come off one at a time and are stacked carefully, since every sound tile reused is one less to match. Work usually goes one section at a time so the house is never left open to weather.
Remove the underlayment
Worn felt, old battens, fasteners and flashing are stripped so the deck is bare. Soft or rotted decking is cut out and replaced with new plywood or OSB.
Rebuild the waterproofing
A modern underlayment system is installed along with new flashing at every valley, wall, chimney and pipe. New battens and new bird stops go on before the tile.
Put tile back
The salvaged tile is relaid course by course with corrosion resistant fasteners, and new or salvaged tile fills any gaps. When the old tile is not reusable, new tile is installed over the new underlayment instead.
Finish the ridge
Ridges and hips are capped, the roof is checked for cracked tiles and the old materials are hauled off. The permit is closed with a final inspection where required.
What is included
Parts of a tile roof replacement
Deck repair
Rotted or soft decking is replaced to carry the weight of the tile.
New flashing
Valleys, walls, chimneys and pipes get new flashing so the roof has no old weak points.
Tile salvage
Tile is stripped by hand and stacked for reuse so as much original tile as possible goes back up.
Tile relay
Salvaged tile is relaid with new fasteners over new battens and bird stops.
Related service
Tile Roof Underlayment Replacement Hillside, NJ
Tile roof underlayment replacement is the most common kind of tile roof replacement, and it keeps the existing tile. Many original underlayments were basic felt, which hardens and splits after years of heat beneath the tile. Modern options like self-adhered membranes and heavy synthetics are built to last far longer.
For tile roof underlayment replacement in Hillside, the roof is usually done slope by slope so tile can be stacked on the next area while the deck is open. Flashing and battens are renewed along with the underlayment, because reusing tired metal defeats the purpose. The result is a roof that keeps its original look over a brand new waterproof layer.
Related service
Clay Tile Roof Replacement Hillside, NJ
Clay tile can last for generations, so replacement on a clay roof often means keeping the tile. Sound clay tile is hard and rings when tapped, while spalled or flaking tile sounds dull and breaks easily. Where enough tile has failed, the roof may be redone in new clay with a matching profile.
For clay tile roof replacement in Hillside, matching matters most on older homes, where the tile defines the look of the house. Salvaged clay and careful placement let the finished roof look like it was never touched.
Local help
Tile Roof Replacement Near Me
In Hillside, older tile roofs often still have their original tile and their original, aging underlayment. Across Hillside and nearby towns like Union, Elizabeth, Roselle Park and Vauxhall, replacements on clay roofs usually reuse the tile, while worn concrete tile is more often swapped for new, and planning the work around the weather keeps each opened section protected.
For tile roof replacement in Hillside, NJ or nearby towns like Union, Elizabeth, Roselle Park and Vauxhall, call (908) 562-6893 to reach a roofer who covers your street.
How the weather here affects roofs around Hillside
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Hillside, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why fix it now
Less damage
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Familiar with local homes
Local roofers see the same roofs and storm damage across Hillside and nearby towns.
Straight answers
Ask the roofer about the cause, the options and the estimate before work starts.
Common questions about tile roof replacement
Can my old roof tiles be reused?
Sound tile can be reused, and on many clay roofs most of it goes back on. Some pieces always break during removal, so matching replacement tile is blended in. Brittle or eroded tile is better swapped for new.
What does relaying a tile roof mean?
Relaying a tile roof keeps the tile but replaces everything under it. It solves leaks caused by worn underlayment while keeping the look of the roof.
How long will replacing my tile roof take?
A tile roof replacement takes longer than a shingle reroof, often a couple of weeks or more for an average home. Deck repairs, structural work and finding matching tile can extend it. The roof is dried in section by section, so the house stays protected.
How do I know if I need a new tile roof or a repair?
A roof that leaks in more than one place and has decades-old underlayment is past patching. Isolated damage can still be repaired. A roofer can lift tiles in several spots to show the condition underneath.
Can a tile roof be replaced with shingles or metal?
Homes with tile can be reroofed in metal, shingles or other materials, as long as the slope suits the new roof. The eaves, flashing and ventilation are reworked for the new material, and local rules or an HOA may limit the choice.
More questions? Call (908) 562-6893
Related services
Tile Roof Installation
New tile roofs planned from the framing up, with the profile, fastening and flashing matched to the house, whether the home is new or switching from shingles.
Learn moreTile Roof Repair
Tile roof repairs from a single cracked tile to relaying a leaking section, matched to the profile and color already on the roof.
Learn moreRoof Replacement
Full tear-off and replacement for roofs that are worn out, storm beaten or leaking in several places, with the old layers removed and the deck checked.
Learn moreTile Roof Inspection
An inspection of a tile roof from the ridge to the attic, with a written report of what needs attention now and what can wait.
Learn more
Looking for something else?
See all roofing servicesGet tile roof replacement help in Hillside
Call now for Hillside tile roof replacement and help in the towns around it.